TYC Tool & Die Maker

· Must be able to follow instructions.

· Able to operate Drill Press, Mill, Grinder, and Lathe with set-up assistance.

· Able to read calipers, micrometers, and indicators.

· Willingness to train new Tool and Die Makers.

· Able to read and understand shop prints.

· Able to complete tasks with minimal assistance.

· Able to make jigs and fixtures.

· Must be able to understand uses and best application for each tool steel.

· Able to complete heat treat process.

· Grind tooling to tight tolerances.

· Understand and use shop math.

· Sharpen and maintain tooling for dies.

· Able to construct tooling for dies.

· Complete set-up of Mill, Lathe, and Grinder independently.

All your information will be kept confidential according to EEO guidelines.

Please note this job description is not designed to cover or contain a comprehensive listing of activities, duties, or responsibilities that are required of the employee for this job. Duties, responsibilities, and activities may change at any time with or without notice. McWane is a Federal VEVRAA contractor, and an Equal Opportunity Employer committed to providing equal employment opportunity in all employment practices. McWane will not discriminate against any applicant for employment because of their race, color, religion, sex, national origin, age, sexual orientation, disability, veteran or service member status, marital status, citizenship status (In IL - sex, including same sex, ancestry, order of protection status, physical or mental disability, military status, pregnancy, unfavorable discharge status, genetic information), (In IA - gender identity), (In CA- gender identity or expression, and genetic information) or any other category protected by federal, state or local law.